Operating instructions

14
• Measured values are given at analog outputs
• 4 set point channels incl. motor potentiometer to set parameters
The specific characteristics especially include the following options:
• LBA-2 local touch display with integrated process data recorder of up to 6 channels
• LBA-2 is downward compatible with LBA and can replace it.
• Cabinet installation kit (SEK) for LBA-2 with touch display. The SEK allows the installation of
LBA-2 in cabinet doors. It comes with wiring and installation frame.
• Bus connection via bus adaptor cards to plug into the Thyro-P Power Controller, coupling to
different bus systems, for instance Profibus, other bus systems upon enquiry.
• The PC-Software Thyro-Tool Family for effective commissioning and simple visualization tasks.
Functions are for instance loading, storing, modification, comparing and printing of parameters,
set points and actual value processing, line diagrams of process data (including printing and
storing option), bar diagrams, simultaneous display of process data from different power con-
trollers, simultaneous connection of up to 998 Thyro-P Power Controllers.
• Patented ASM procedure for dynamic mains load optimization. The ASM procedure (automated
synchronization of multiple power controller applications) is used for dynamic mains load optimiza-
tion. It reacts to changes in load and set point, minimizes mains load peaks and associated mains
feedback. Minimizing of mains load peaks means cost savings in operating and investment cost.
• For new systems it is recommended to use the high performance dASM instead of ASM.
NOTE:
After purchasing Thyro-Tool Family software updates (if available) can be downloaded for free from
our homepage.
1.3 TYPE DESIGNATION
The type designation of the thyristor power controllers are derived from the construction of its
power section:
TYPE RANGE DESIGNATION FEATURES
Thyro-P 1P 1-phase power section,
for single phase operation
2P 2-phase power section
3-phase loads in thress phase economic circuit
(not for phase-angle firing VAR)
3P 3-phase power section,
for three phase operation
.P400 Type voltage 230-400 Volt, 45-65 Hz
.P500 Type voltage 500 Volt, 45-65 Hz
.P690 Type voltage 690 Volt, 45-65 Hz
.P ...-0037 Type current 37A (Typecurrent range 5A-2900 A)
.. ...-.... . H Integrated semi-conductor fuse (all Thyro-P)
.. ...-.... . F Forced air cooling with integrated ventilators
The complete type range can be found in the TYPE OVERVIEW in chapter 10.