Operating instructions

ManualsBrandsAEG ManualsComputer equipmentARE I2

For transport, assembly, installation, commissioning, operation and decommissioning, the safety

instructions contained in these operating instructions must be applied in any case and made

available to all persons handling this product.

CAUTION

It is important that preset parameters are not adjusted in any way that may cause the Power Con-

troller to overload. In case of uncertainties or missing information, please contact your supplier.

1.1 GENERAL

Thyro-P is a communication enabled SCR thyristor power controller. Below, it is also referred to

simply as power controller. The Thyro-P power controller can be installed everywhere where volta-

ges, currents or power have to be controlled precisely in 1- or 3-phase networks. Several modes of

operation and control, good coupling ability to process and automation technology, high control

precision by application of a 32 bit processor and simple handling ensure that Thyro-P is also suita-

ble for new applications.

Thyro-P offers new ways for mains load optimization:

• In operating mode TAKT, the optional digital mains load optimization of dASM ensures that mul-

tiple power controller applications can be used in an optimal way for the network so that system

perturbations are mainly avoided.

• For applications which have to use phase angle ﬁring due to required high dynamic, Thyro-P...VSC

offers to minimize signiﬁcantly harmonics by its VSC technology.

Thyro-P is suitable in particular for

• direct supply of ohmic loads

• for loads with large R

hot

cold

ratio

• as primary power controller for a transformer with subsequent load

Due to use of high quality thyristors, the Thyristor Power Controller Thyro-P has a type range

up to 2900A, the nominal design loads reach up to about 2860kW.

1.2 SPECIFIC CHARACTERISTICS

Thyro-P is characterized by a multitude of speciﬁc characteristics, for instance:

• easy handling

• menu-driven user interface (options: LBA-2 with touch display, Thyro-Tool Family)

• type range 230-690 Volts, 5-2900A, single, double, triple phase

• broadband power supply AC 200-500V, 45-65Hz

• ohmic load and transformer load

• as well as load with large R

hot

cold

for 1P and 3P

• soft start function for transformer load

• load circuit monitoring

• automatical rotating ﬁeld recognition for 2P and 3P

• U, U

, I, I

, P control as well as without control

• operating modes TAKT, VAR, VSC_VAR, SSSD, MOSI (optional sub operating mode of TAKT and

VAR)

• mains load optimization dASM for applications with multiple power controllers in operating

mode TAKT

• control of analog set points or via interfaces

• ﬁber optic and RS232 interfaces as standard

• electrical separation according to EN 50178 chap. 3

1. INTRODUCTION