Operating instructions

11
VALIDITY
These operating instructions refer to latest technical specification of Thyro-P at the time of publi-
cation and are for information purposes only. Every effort has been taken to ensure the accuracy of
this specification, however, in order to maintain our technological lead and for product enhance-
ment, we are continually improving our products which could, without notice, result in amendments
or omissions to this specification. Advanced Energy Industries cannot accept responsibility for
damage, injury, loss or expenses resulting therefrom.
HANDLING
These operating instructions for Thyro-P are organized so that all work required for commissioning,
maintenance and repair may be performed by corresponding specialist personnel.
If hazards to personnel and property cannot be excluded for certain work, then this work is marked
using certain icons. The meaning of these icons may be found in the prior chapter safety regula-
tions.
ABBREVIATIONS
In this description, the following specific abbreviations are used:
AEI = Advanced Energy Industries GmbH
dASM = digital mains load optimization, dynamic
ASM = automatic synchronization in multiple power controller applications
(dynamic mains load optimization, not for new installations)
LBA-2 = Local operating and display unit with touch display
LBA = Local operating and display unit (not for new installations)
SEK = cabinet installation kit
LL = fiber optic
LLS = fiber optic transmitter
LLE = fiber optic receiver
LLV.V = fiber optic distribution supply
LLV.4 = fiber optic distribution, 4-fold
MOSI = heating system for molybdenum discilicide
SP = set point
SYT = synchronized clock
WARRANTY
Customer shall provide written particulars, enclosing the delivery note, within 8 working days to
Advanced Energy Industries on becoming aware of any defects in the goods during the Warranty
period and shall use
its best endeavors to provide Advanced Energy Industries with all necessary access, facilities and
information to enable Advanced Energy Industries to ascertain or verify the nature and cause of the
defect and carry out its warranty obligations.
If goods are found not to be defective or if any defect is attributable to Customer’s design or
material in operation of the goods, Advanced Energy Industries will levy a testing charge and where
relevant will return the
goods to Customer at Customer’s expense, and shall be entitled to payment in advance of the
whole testing and transport charge before such return.
Advanced Energy Industries accepts no liability for defects caused by the Customer’s design or ins-
tallation of the goods; or if the goods have been modified or repaired otherwise than as authorized
REMARKS ON THE PRESENT OPERATING INSTRUCTIONS AND THYRO-P