User manual

ManualsBrandsAEG ManualsFor HomeA5200AZ

Thermal cut-off

This vacuum has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum switches off,

turn the switch to off position and unplug the vacuum. Check the vacuum for a possible source of overheating such as a

full dustbin, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before

attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and press the power switch to turn

on (I). If the vacuum still does not run, please call Electrolux Customer Care Helpline.

Problem solving

Problem

Motor will not start.

Vacuum does not

clean carpet.

No suction at the

end of hose.

Stair and upholstery

brush will not turn.

Vacuum is hard

to push.

Burning smell; brush roll

will not turn.

Cause

Solution

Power switch

• Push power switch to turn vacuum on.

Thermal cut-off

•

See above.

Dust bin and filter

• Empty dust bin, clean and/or change filter.

• If picking up fine dust, the dust bin may not look full, but

a fine substance tends to reduce suction when it blocks

air flow through the filter and screen. Refer to page 3 for

filter maintenance. Make sure filter, screen and dust bin

are installed properly.

Hose/valve assembly

• Remove clogs from the hose that restrict the airflow. Page 5.

• Clear blockage from hose/valve assembly. Page 5.

• Make sure air path selector knob is turned to ‘FLOOR'

setting. Page 4.

Belt

• Replace a worn, cut, or out of shape belt. Page 6.

Carpet height setting

• Turn carpet height selector to another setting. Page 3.

Dust bin and filter

• Empty dust bin, clean and/or change filter.

• If picking up fine dust, the dust bin may not look full, but

a fine substance tends to reduce suction when it blocks

air flow through the filter and screen. Refer to page 3 for

filter maintenance. Make sure filter, screen and dust bin

are installed properly.

Hose/valve assembly

• Remove clogs from the hose that restrict the airflow. Page 4.

• Clear blockage from hose/valve assembly. Page 4.

• Make sure air path selector knob is turned to ‘HOSE'

setting. Page 3.

Rotating brush

• Check stair and upholstery brush for debris.

Carpet height setting

• Turn carpet height selector to another setting. Page 3.

Belt

• Replace a worn, cut or out of shape belt. Page 6.

Belt

• Check brush roll for debris. Page 5.

• Replace broken or out of shape belt. Page 6.

Make sure vacuum is turned off and power cord is unplugged.

Electrolux Customer Care HELPLINE 08445 614614

Calls to this number will be charged at 5p per minute at all times from a BT Landline.