Table of contents Safety instructions For the installer For the user Description of the appliance Features 618 K Description of the appliance Features 618 K8 Hobs General How the induction cocking-zones function Functional safety Using the induction Output settings 618K8 Output settings 618K Table for cooking and frying Care and cleaning Wheatstone done if ? After-sales service 27 28/30 31 43/45 46/47 48
Safety instructions Manufacturers are required by safety regulations to | For the give the following instructions. instanter The enclosed installation instructions are to be followed when installing in kitchen cabinets, «CE» This equipment conforms 1o the following EC directives TH2YEEC gated 19,02 1973 low voltages directive BREECH dated 03.05.1989 (including amendment directive. 92/31/EEC) Dir.
For the user information for users with pacemakers Safety instructions While you are cooking, the hob surfaces get hot. You should therefore basically keep small children well away. Overheated fats and oils rapidly ignite. If you are cooking food in fat or oil {e.g. chipped potatoes, you are advised 1o remain in the vicinity. The ceramic cooking area should not bs used as 2 storage area Never place any pan lid an the induction hotplate when it is switched on {or you may burn yourself).
Safety instructions Electromagnetic fiends may influence electronic circuits. Electromagnetic fiends may cause interference on portable radio sets. Never place any jewelry, watches, credit cards, cassettes, etc. on the ceramic cooking area, since the latter will get hot during cooking or may be damaged. Never heat any closed cans. Never place any metal objects on the induction cooking area, since these may in some circumstances heat up during cooking.
Safety instructions induction cooking hob saucepans: Please only ever use steel-enameled cooking utensils, cast-iron pots and pans, or other saucepans specially designed for induction hobs {aluminum with a steel bottom. Chrome-nickel steer saucepans with ferromagnetic parts are 10 an extent suitable if they are identified by the manufacturer as being suitable for induction hobs. 8o, please never under any circumstances use pots or pans made of aluminum, copper, brass or stainless sties.
Description of the appliance 818K m——e EDGE EDF G A W Minus ‘and Plus + for adjusting the timer clock {only for the cooking zones at front left and Features rear right) B Indicator for the length of cooking time {only for the cocking zones at front left and rear right) € Residual heat indicator, lights up when the cooking zone is hot; once it has cooled down again the light gods out. D Indicator for the arrangement of the cooking zones, eq.
818 Ks Features Description of the appliance e Sees Eyre A EFG ERa # Boc EDF A Minus @ und plus button for setting the timer {for the front left and rear right hotplates only). B Cooking duration display field {for the front left and rear right hotplates only). € Residual heat indicator remains lit as long as the hotplate is hot, when the hotplate has cooled, the indicator switches off. B Cooking zone coordination indicator, ag. front right. & Cooking zone On/Off button. Cooking zone power stage indicator.
On/Off button Hotplate coordination indicator Warming zone power setting On/Off pilot lamp Power stage pilot lamp 618 K8 Features
General « Cooking saucepan Hobs M The better the pot, the better the cooking. M You can recognize the right cooking pots and pans by the bottoms, and not by the material the pot is made of. M The bottom must be as thick and flat as possible, and must not be rough, because scratches could be caused when it is moved around. W Use tall-sided pans for dishes involving a large amount of liquid, so that nothing can boil over.
Hobs Bif you would like to use a container with a non-stick coating (e.g. Teflon), please avoid using the «P» {for power} heat setting. Wi you save an object or an empty container on 8 hob which is switched on, the appliance’s safety system wilt automatically be set off. There is nevertheless a danger of the object or container being damaged, ®|Do not heat up any unopened cans. These will definitely burst. Incidentally this applies to all other cooking appliances as well.
Hobs Do not place any objects will a magnetic charge {e.g. credit cards, tape cassettes, ac} on the glass-ceramic surface when it is in use.
The induction hob is fitted with safety devices to protect the electronic system. More safety A fan located on the rear side of the cabinet draws in outside air and blows it forwards through openings fitted in the vicinity of the contort panel, thus protecting the electronic circuit from excessive heat. % The fan has two speeds of operation, so that the current of air can be adjusted to surf the degree of heating of the electronic system.
Switching on 618K 818 K8 Betting the output of the cooking zone Using the induction cooking-zone Place your finger vertically and flat onto the required but tort until the relevant pilot light comes on or gods out. You can see which cooking zone is allocated to sate button with the help of this symbol § Then press the On/O#f button (1), By using Button G you can reduce the heat output from a maximum minimum of 1 without switching the cooking zone off.
Setting on the cooking time Switching off the cooking zone Press the On/Oft Button [(Di. Switch on the heat output. Enter the required cooking time by pressing the buttons The display shows the cooking time still remaining. ‘This can be altered at any time. When the per-set time has finished the cooking zone automatically switches off, and the figure on the display disappears.
Output settings 618K8 The front left and the right rear cooking zones have a POWER setting with an output from 50 to 2800 Watts. The front right and the rear left cocking zones have output settings from 50 to 1000 Watts, 2800 W 1000 W Output in Watts
The front left and the right rear cooking zones have a Output POWER setting with an output from 50 to 1800 Watts.
Setting Cooking process Examples of use 1800w Hob | 1000w Hob with L POWER | (POWER: setting smelting P P Heating up o buying ks, soups, or vegetables to the bol g 9 Heating fat Heating frying-pans, Roasting Goulash, roasting meat, Keying chips, cooking fresh nobodies 8 8 Frying, baking Pancakes, potato-cakes in the pan fillet steaks 7 7 Frying, baking River, sausages, in the pan browning cubes of toast, filet of fish 7 7.
Glass ceramic hob plate basic principles Difficult kinds of dirt Care and cleaning As the heat sanded for cooking is generated in the saucepan itself, the cooking Zone itself hardly warms up at all, except for absorbing heat from the saucepan standing on it Thus splashes, or any food that may boil over, does not burn on to the cooking zone. #t is important to clean the hob plate every time that it has been used 1 Never use harsh cleaners such as coarse abrasive pow-| reds or scratchy pot-cleaners.
Burnt-on sugarcoated plastic Remove it at once, while it is stile hot, with a glass-scraper, or the hob piste may suffer damage. Then clean the whole hob piste ag described above as Point 3. You can take precautions against damage from sugar or food containing sugar by cleaning the glass-ceramic hob plate with a product such as «Colo-Profi» or «Ceramic, which are designed to clean and shine ceramic tiles.
Grains of sand which fall on the hob plate can cause scratches when pots are moved about, so please make sure that no sand remains on the hob plate. Scratches have no effect on the solidity of the hob plate. Decoration rubbed off If harsh cleaning products are used, or as & result of sauce-pans scuffing, the decoration wolf gradually nib off the hob plate over time and dark patches will appear.
What'’s to be done you shouts ever have the impression that your induction hob plate is not working perfectly, it does not necessarily mean that something needs repair. Please check the following points. The induction cooking zone is not waking. The pilot lights on the control panel do not come on. The appliance is not being supplied with power. There is a failure in the mains network, or the appliance is not correctly connected. Check the electrical system in the house, particularly the fuses.
What's to be done if 7 The induction cooking zone switches off during operation. FO appears in the time-switch display. Wait for about 10 minutes after switching on the hob, until the pilot lights for the about settings have stopped flashing, The induction cooking hob is now ready for operation, The cooking zone makes a clicking noise. This happens when the output is being distributed over two cooking zones.
Customer service # you cannot find any reference to a particular fault in the operating instructions, please compact our service center. When doing so, quote the E-No. and F-No. which you dint in the note accompanying the hob plate, Your indication of these numbers enables the service center 1o make precise identification of the required spare part so that the hob can be repaired at the engineer’s first visit.
AEG Tannhauser AG Posthaste 1036 D-80327 Nirenberg 1 © Copyright by AEG H 260 275 400 9953 7821 03/97 AEG Domestic Appliances Lid Customer Care Department 55-77 High Street Slough Berkshire SL1 1DZ Telephone: 08705 350350
