User manual

15
1. : Mute button
2.
: Power on / Standby button
3.
Button: Press to return to the main menu.
4.
: Increase volume button
5.
: Decrease volume button
6.
Button: Press to go back to previous track
7. Button:Presstochangetonexttrack
8. Play / Pause button
9. MODE Button: Switch between audio sources.
10. : Cursor up button
11. : Cursor left button
12. : Cursor right button
13. : Cursor down button
14. OK Button
15. 0~9: Call up favorites / memory, Input letters and num
-
bers
16. EQ Button
17. INFO Button
18. PRESET Button
19.
: Sleep Button
20. ALARM Button
21. TIMER Button
To remove the batteries from the remote, use your thumb
to pull out the battery compartment cover.
Replace them with a two AAA type batteries
CAUTION:
Riskofexplosionifbatteriesarereplacedbyanincorrect
type.
Dispose of used batteries according to the instructions.
Symbols on the display
Connection is being established, device functioning
Wireless connection established
FM radio function selected
FM radio reception: Mono
FM radio reception: Stereo
Speaker muted
Alarm on

Internet radio station saved as favorite
Getting Started
Thepackagingboxcontainsthefollowingitems:
- IR 4468 BT Internet radio
- Remote control
- AC power cord
- 3.5 mm adaptor cable
- 3.5 mm to RCA-jack adaptor cable
- User manual
Get the network ready
• ForWirelessLAN(WLAN)connection:
Check if the WLAN LINK / ACT light of the wireless
access point or router is illuminated. Consult its user
manual if there are any questions.
NOTE:
Wi-Fi allows data transfer over short distances within
20 meters without the need of cabling between the
devices. Any walls or ceilings may reduce the strength
of the Wi-Fi connectivity.
Therefore try to locate the IR 4468 BT and / or the
access point within the distance mentioned above,
and avoid any obstacles between two devices.
• ConnectthepowercordtotheACsocket(14)onthe
backside of the appliance.
• Duringtheinitialstartoftheappliance,thesystemwill
ask you to set Language and Network Configuration.
• Firstscreen:Select“Yes” to check for networks when
turning on the alliance.
• Secondscreen:Select“Yes” in the second screen to
establish the connection with the network.
• Select“Yes (WPS)” (only for WPS routers). Then press
the WPS button on your router.
• Select“No” if you prefer to listen to a terrestrial station
orifyouwanttousethespeakerwithanexternalplay
-
back device.
• Ifselected”Yes”, the display starts scanning for wireless
networks and shortly afterwards a list of available wire-
less networks is shown.
• Thenumberofbarsinthewirelesssymbolinfrontofthe
network name (SSID) shows the relative signal strength
of the network.
• Thekeysymbolindicatesthatthenetworkisprotected
by password.
• Ifthedevicedoesnotndanywirelessnetworks,“No
Wireless Networks Found” appears on the display. If
necessary change your location and check your WLAN
router.