User manual

English
31
14 Sleep timer active
Rear (not shown)
Dipole antenna
Power adapter socket - DC 5 V
Bottom (not shown)
Battery compartment
Start-up of the device/ Introduction
• Chooseasuitablelocationforthedevice.Suitablewould
be a dry, level, non-slip surface.
• Sensitivesurfacessuchasthedisplayarepossiblypro-
tected with foil. Remove these foils.
Display lighting
• Mains operation: The display is lit continuously. Press the
SNOOZE/LIGHT button in order to increase the intensity
of the display lighting for 8 seconds.
• Battery operation: The display backlight turns off auto-
matically. Press the SNOOZE/LIGHT button. The display
is lit for 8 seconds.
Power supply
1. Make sure the grid voltage corresponds to the figures on
the rating plate.
2. Plug the power supply unit into a properly installed
protective contact socket.
3. Connect the device with the power supply unit by
plugging the jack of the power supply unit into the
“DC 5 V
” jack.
CAUTION:
• Thisdeviceshouldonlybeusedwiththemainssupply
unit (included). Do not use it for other devices.
• Onlyusea5Vpowersupplyunit(
). A different
supply unit may damage the device.
NOTE:
• Disconnectfrommainspowersupplyduringlonger
periods of non-use.
• Ifyoudidnotinsertanotherreservebattery,thetime
and the station memory will be lost as soon as the
power supply is interrupted.
Inserting the reserve batteries
(Batteries are not included in the scope of delivery)
In case of power failure or if the power supply unit is pulled
from the plug, the settings are maintained if the reserve bat-
teries are inserted.
1. Open the battery compartment on the bottom side.
2. Insert three type AA/R6 1.5 V batteries. Check that the
polarity is correct (see battery compartment).
3. Close the battery compartment.
WARNING:
Donotexposethebatteriestointenseheat,suchassun-
light, fire or similar. Danger of explosion!
CAUTION:
• Batteriesmayleakandlosebatteryacid.Ifthedeviceis
not used for a longer period of time, remove the bat-
teries.
• Differentbatteriesornewandusedbatteriesmaynot
be used together.
• Batteriesmustnotbedisposedofinthegarbage.
Please bring used batteries to competent collection
centers or back to the dealer.
NOTE:
Battery operation is also possible with the inserted batteries.
Switching the device on/ off
• PresstheRADIOON/OFFbuttontoturnthedeviceon
or off.
• Inordertofullydisconnectthedevicefromthemains,
unplug the power adapter from the wall socket.
Temperature display
The current ambient temperature is shown on the bottom
right of the display.
The temperature display can be switched between °C (De-
gree Celsius) and °F (Degree Fahrenheit).
1. Turn off the device.
2. Press the UP button repeatedly.
Setting the Clock
Automatic (in Standby only)
• Afterpluggingthemainsplugintothesocket,thetime
data from the DCF77 station is automatically transferred
after a few minutes. As long as the “
”symbolisash-
ing, the device is searching for the radio signal. If a radio
signal has been found, the “
” symbol lights up. The
correct time appears on the display.
• Thetimeisautomaticallysynchronizedapprox.every
2 hours via transmitter signal.
• Duringsummertime“
” appears in the display.
NOTE:
The signal can be received without problems within a
radiusofapprox.2000kmaroundFrankfurt/Main,but
interference may occur, depending on local conditions.
This may occur especially in buildings containing a high
percentageofmetal,aswellasinproximitytoTVsets,PCs,
mobile phones etc. which are switched on! If the reception
cannot be automatically adjusted after 10 minutes in spite
of the alignment of the integrated antenna, the reception
in the respective location is too weak. In this case, set the
time manually or change location.