Instruction Manual
Maintenance
Cleaning the drawer recess
Having removed the drawer, use a
small brush to clean the recess
ensuring that all washing powder
residue is removed from the upper
part of the recess. Replace the
drawer and run programme 4 for a
few minutes and then the drain cycle
15 to clear any residues.
The dangers of freezing
If the machine is exposed to
temperatures below 0°C, certàin
precautions should be taken.
Turn off the water taps and unscrew
the inlet hoses.
Select a wash programme and run for
a few seconds.
Unhook the drain hose from the rear
support and position the end in a
bowl. Run the draining programme for
a few seconds.
When you intend to start the machine
up again, make sure that the room
temperature is above 0°C.
34
Installation instructions
13
Electrical connection
WARNING:
THIS APPLIANCE
MUST BE EARTHED
The manufacturer declines any
liability should this safety measure
not be observed.
If the plug that is fitted to your
appliance is not suitable for your
socket outlet, it must be cut off and
the appropriate plug fitted.
The cut off plug should be disposed
of to prevent the hazard of electric
shocks in case it should be plugged
into a 13 Amp socket in another part
of your home.
Important
The wires in this mains lead are
coloured in accordance with the
following code;
GREEN AND
YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
If you fit your own plug, the colours
of the wires in the mains lead of your
appliance may not correspond with
the markings identifying the terminals
in your plug, this is what you have to
do:
Connect the green and yellow (earth)
wire to the terminal in the plug which
is marked with the letter «E» or the
earth symbol or coloured green,
or green and yellow.
GtjiMieai me blue (neutral) wire to the
terminal in the plug which is marked
with the letter «N» or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the
letter «L» or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement,
use a 13 Amp BS 1362 fuse.
Only ASTA approved fuses should be
used.
The fuse cover/carrier must be
replaced in the event of changing
fuse.
The right fuse cover/carrier colour is
the one shown by the coloured insert
at the base of the plug.
The plug must not be used if the fuse
cover/carrier is lost.
A replacement cover/carrier must be
obtained from AEG Service Agents.
a
This appliance complies with
the following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent modifica
tions;
- 89 / 336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subse
quent modifications.
11