User manual

4. Using a 8mm masonry bit, drill the holes for the

canopy and fan assembly and insert the rawl

plugs ready for the fixing screws.

5. The hood is supplied with the air outlet facing

the rear. To rotate the extractor to face left or right

proceed as follows:

(A) Loosen the screws (V1), turn the extractor 60° to

the left or right as required, then tighten the

screws.

(B) To fix the bracket (S), select the left or right hand

screw holes and using the screw (V2) secure the

bracket.

6. Unscrew the four self tapping screws and remove

the plastic surround.

7. Fit the ducting spigot (R) using the four self

tapping screws and replace the plastic cover.

8. Fix the round eyelet screws provided tightly into

holes (1) and hook on the canopy (C) ensuring

the hooks are located into the eyelets before

releasing the canopy.

9. Unscrew the self tapping screws from the back

of the fan assembly and remove the plastic

surround.

10. Fit the ducting flange (F) onto the fan assembly

utilising the same fixing holes and self tapping

screws.

11. Insert the 4.2x44.4mm screws provided for fixing

the fan assembly and chimney into the wall and

tighten about two thirds. Lower the fan assembly

and chimney onto the fixing bracket (S), then fully

tighten the screws.

INSTALLING INSTRUCTIONS

S07_18

S07_22

S07_19