User manual

34
InstallationInstallation
InstallationInstallation
Installation
● Rest the template correctly against the wall. The lower
corner of the template corresponds to the lower corner of
the extractor hood.
Fig. 3.Fig. 3.
Fig. 3.Fig. 3.
Fig. 3.
● A cross is marked
on the template
to indicate the
centre. Mark
this point on
the wall.
Fig. 3.Fig. 3.
Fig. 3.Fig. 3.
Fig. 3.
● Drill two holes (Ø 8 mm) in the
wall at the points indicated,
insert the stops (Ø 8 mm) and
screw in the hooks provided.
Fig. 3.Fig. 3.
Fig. 3.Fig. 3.
Fig. 3.
● Hang the hood and adjust its
position using the screws on the
hooks.
Fig. 4.Fig. 4.
Fig. 4.Fig. 4.
Fig. 4.
● The reference point “
aa
aa
a”
marked on the body of the
extractor hood must coincide
with the line you have drawn
on the wall.
Fig. 4.Fig. 4.
Fig. 4.Fig. 4.
Fig. 4.
● Once the extractor hood has been correctly aligned,
remove the grease filter.
Fig. 3Fig. 3
Fig. 3Fig. 3
Fig. 3
Fig. 4Fig. 4
Fig. 4Fig. 4
Fig. 4