User manual

● Proceed as follows to remove and change my activated

carbon filter:

● Switch of the fan motor by pressing the

button.

● Take the precaution of removing my cartridge fuses from

their fuse holders or tripping my automatic circuit

breaker to ensure the fan motor cannot be switched on

accidentally.

● The activated carbon filter cannot be cleaned or reused.

●●

● Remove the metal filters.

● Unscrew the two screws on the activated carbon filter

frame and remove the old filter.

Fig. 2Fig. 2

Fig. 2.

●●

● Clean the inner housing using a hot detergent solution

only (never use caustic detergents, abrasive powders or

brushes).

Mounting the carbon filter:Mounting the carbon filter:

Mounting the carbon filter:

● Insert a new activated carbon filter into the carbon filter

frame.

Fig. 2Fig. 2

Fig. 2.

● Close the activated carbon filter frame again using the

two screws provided.

●●

● Refit the metal filters.

●●

● Screw the fuses back in or reset the automatic circuit

breaker.

●●

● Proceed as follows to reset the filter saturation display

(counter): Select any fan speed using

E or F buttons

and then press the

B and F buttons at the same

time, continuing to hold them down for at least 3 seconds

until the flashing letter C stops being shown on the

display (D) and then press the

button B.

●●

● The activated carbon filter display is now ready for use

again.