User manual

29
To ensure correct operation of the UPS and its ancillary equipment, it is
necessary to equip the power cord with an appropriate fuse. For all
models in the Protect C series connection is made via the supplied
mains lead to a standard electrical outlet. Utilize a sufficient fuse rating in
your sub-distribution. In particular, the Protect C.3000 requires its own
16 A protection. Initially, do not yet insert the safety plug of the power
cord in the dedicated electrical outlet.
6.4 CONSUMER CONNECTION
Before making the connection of loads to the UPS, please check that the
specified power rating on the type rating plate is greater than or equal to
the sum of consumer services. Connect the provided consumers with the
outlets of your UPS. To do this, use the enclosed consumer connection
lines. Initially consumers must be turned off. If additional load connection
cables are required, please contact your dealer.
The UPS consumer load should not exceed the specified rated load of
the devices at any time. If a device becomes overloaded, the red fault
LED lights up, accompanied by a beep. The supply to the connected
loads is dependent on the magnitude of the overload valid for a certain
time; however, the connected load must be reduced immediately. Non-
observance of the "device overload" can lead to a total loss of all UPS
functions!
Avoid short-term device overloads, which can arise, for example, when
connecting a laser printer or a laser fax machine. Do not connect
household appliances and machine tools to the UPS.