User Guide

--------------------------------------------------------------------------------9/18--------------------------------------------------------------------------------
3
4
5
1
6
Cable
7
5.3.3 Mounting of the Power Supply Cable
The power supply cable must be mounted in following steps:
• Prepare the SAB cab according to chapter 5.3.2
• Remove all inner parts from the cable pipe at the SAB cab (1) ( nut (5), pipe(4) and cable fasten-
er (3)) (see Figure 5-3)
• Put all the removed parts ( nut (5), pipe (4), cable fastener (3)) and the cable pipe of the SAB cab
as well (1 to 4) to the cable.
Figure 5-3: Arranged Parts for Mounting of the SAB Cab
• Remove the outer isolation of
the cable at a length of 6cm .
• Remove the isolation of the
wires at a length of 6 [mm] and
stick a covering hull to the litz
wire.
• Put the cable through the cable
pipe. The length of the cable coming out the SAB cab must be long enough to do all further instal-
lation steps in an easy way.
• Stick the pipe (4) into the cable fastener (3).
• Stick the cable fastener (3) into the cable pipe.
• Connect the power supply cable into the right places of the MINI-COMBICON-connector (see Fig-
ure 5-3 Part (6)).
• The pin assignment is shown in the figure below.
24VDC
L
+U
S
-U
S
U
L
blue
blue
brown
( Dig-In - )
( Dig-In + )
0V / GND
+24V
DC
not used
not used
not used
not used
not used
not used
Figure 5-4: Pin Assignment for Power Supply Cable
5.3.4 Final Assembly of the Cable Pipe
• Plug the finished assembled MINI-COMBICON-connector to the SAB cab. Take care of the cor-
rect coding ((7) in Figure 5-3) of the connectors.
• Pull by and by all the cable back, until the isolation of the cables are near to beginning of the ca-
ble pipes.