User's Manual

ManualsBrandsAEG Identifikationssysteme ManualsElectronicsRFID Reader

--------------------------------------------------------------------------------25/26--------------------------------------------------------------------------------

6.3 List of error messages

error number function error-LED

#00 command code not known, wrong code no

#01 stack-error (under- / overflow) no

#02 parameter value not valid no

#03 error in EEPROM no

#04 function not supportet no

#05 reserved no

#06 reserved no

#07 reserved no

#08 reserved no

#09 kein Code gelesen (NoRead) no

#10 antenna error yes

#99 system o.k. (DIAG state messages) no

Table 6.2: List of error messages

6.4 List of system commands

command-

code

function action on interface Compability

with ASB1.0

DIAG diagnosis / state of the reader state or error message no

GT read transponder (get tag) transponder number yes

INIT load basic configuration boot message / <CR> yes

RST warm start boot message / <CR> yes

VER Output version number version number yes

VS Output of all parameter values List of parameters yes

VSAVE store current configuration ok yes

Table 6.3: List of system commands

6.5 List of parameters and default values

com-

mand-

code

function universally

defined

parameters

(ASB 1.0)

valid pa-

rameter

values for

ARE K1

default-values

MD mode of operation 0 .. 2 0 .. 2 2 (triggered by interface)

BD baud rate 0 .. 3 0 .. 3 2 (19200baud)

EC echo 0, 1 0, 1 0 (off)

CN suppression of NoRead 0, 1 0 .. 2

0 (ou

tput FFFFFFFFFF)

CID filter function for multiply read IDs 0, 1 0, 1 0 (filter off)

NID number of identical IDs per reading cycle 0 , 1 0 , 1 1 (two out of two)

NRD superimposition of telegrams 0 .. 2 0 .. 2 1 (two telegrams)

RNR reader identification number - 0 .. 9, 10..

0 (not active)