User's Manual

--------------------------------------------------------------------------------14/26--------------------------------------------------------------------------------
• after entering the command line CID <SP> 1 <CR>
This causes that the next transponder code is output definitely.
caution: The filter function CID picks up the results of the complete reading cycles,
while the parameter NID proceeds from the results of single readings! The filter
function CID has effect on the serial interface only. The digital output QR1 is
not effected by CID.
4.4 CN
The CN parameter defines the type of NoRead output.
input format: CN <SP> parameter <CR>
Parameter Function
0 issue NoReads on serial interface using FFFFFFFFFF
1 suppress NoReads on serial interface
2 issue NoReads on serial interface using <NAK> #09 <CR>
5
output (example): 0 <CR>
4.5 DIAG
A self-diagnosis is executed. An antenna test is included.
input format: DIAG <CR>
function: A test of the antenna is executed . After this either the message <NAK> #99
<CR> (o.k.) is output on the interface or the message <NAK> #10 <CR> (an-
ntenna failure).
annotation: With an antenna failure the Error-LED is set.
5
parameter value 2 is not compatible down to ASB 1.0