User's Manual

Rev 09
--------------------------------------------------------------------------------19/27--------------------------------------------------------------------------------
3.3.9 VS – variables show
With the command VS the reader shows the settings of the following parameters:
BD, CID, CN, EC, MD, NID, TOR
Input format: VS <CR>
Output (example): BD <SP> 0 <SP>
…
3.3.10 SA – algorithm selection
With the command SA the algorithm can be selected. Depending on the algorithm, the reader adapts its
communication to the transponder suitable for the chip type respectively data format that shall be used.
With parameter 0 ~ algorithm 14 ~ EM4305, EM4569 transponders additional commands to read and
write selective (RD, WD) are available. With parameter 1 ~ algorithm 5 ~ ISO FDX format there are
specific commands as well. This algorithm specific commands are listed in the “Addon_A..” documents.
Input format: SA<SP>parameter<CR>
Output (example): 1<CR>
Parameter:
PARAMETER FUNCTION (CHIP, FORMAT)
0 A14 ~ EM4305, EM4569
1 A5 ~ ISO FDX