User manual

• symbol on: the door cannot be opened. The appliance is running or the appliance has
stopped with water left in the tub.
• symbol off: the door can be opened. The washing programme is finished.
Stand by
If your laundry is not removed within 10 minutes after the programme is finished, the
backlight of the display switches off and the energy saving system will be enabled. Only
the button 8 pilot light is blinking to indicate that the appliance has to be switched off. By
pressing any buttons the appliance will come out from the energy saving status and you
could set another washing programme or switch off the appliance.
Indicator pilot lights (10)
If the OVERDOSAGE (OVERDOSERING SURDOS‐
AGE) pilot light 10.1 goes on at the end of the
programme, it indicates that too much detergent
has been used.
When the appliance is performing additional rin‐
ses the EXTRA RINSE (EXTRA SPOELEN RINCAGE
PLUS) pilot light 10.2 illuminates. To add an ad‐
ditional rinse, please see chapter «Select an addi‐
tional rinse».
First use
• Ensure that the electrical and water connections comply with the installation instruc‐
tions.
• Remove the polystyrene block and any material from the drum.
• Before the first wash, run a cotton cycle at the highest temperature without any laundry
in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2
a measure of detergent into the main wash compartment and start the machine.
Personalization
Acoustic signals
The machine is provided with an acoustic device, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultaneously for about 6 seconds, the acoustic signal is
deactivated (except for the events of operating problems). By pressing these 2 buttons
again, the acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended and not to worry that children
might be injured by or cause damage to the appliance.
8