User manual

4. Select the required options by pressing
the relevant buttons.
If possible, do not select a spin speed
lower than that proposed by the appli-
ance to avoid too long a drying time
therefore saving energy.
In any case the reduction of the spin
speed is only possible after selecting dry-
ing.
The lowest values you can select are the
following:
– 900 r.p.m. for cottons and synthetic
with electronic drying;
– 900 r.p.m. for cottons and 700 r.p.m.
for fabrics with timed drying.
5. Select the drying time by pressing button
5 or dryness degree by pressing button
4 . The display shows the entire duration
of the washing and the selected drying
cycle.
6. Start the programme by pressing button
8 . After the programme has started, the
time remaining is updated every minute.
7. At the end of the programme turn the se-
lector dial to the O position to switch the
machine off.
8. Remove the laundry.
Helpful hints and tips
Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer’s washing
instructions. Sort the laundry as follows:
whites, coloureds, synthetics, delicates,
woollens.
Before loading the laundry
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
New coloured items may run in the first wash;
they should therefore be washed separately
the first time.
Button up pillowcases, close zip fasteners,
hooks and poppers. Tie any belts or long
tapes.
Remove persistent stains before washing.
Rub particularly soiled areas with a special
detergent or detergent paste.
Treat curtains with special care. Remove
hooks or tie them up in a bag or net.
Removing stains
Stubborn stains may not be removed by just
water and detergent. It is therefore advisable
to treat them prior to washing.
Blood: treat fresh stains with cold water. For
dried stains, soak overnight in water with a
special detergent then rub in the soap and
water.
Oil based paint: moisten with benzine stain
remover, lay the garment on a soft cloth and
dab the stain; treat several times.
Dried grease stains: moisten with turpen-
tine, lay the garment on a soft surface and
dab the stain with the fingertips and a cotton
cloth.
Rust: oxalic acid dissolved in hot water or a
rust removing product used cold. Be careful
with rust stains which are not recent since the
cellulose structure will already have been
damaged and the fabric tends to hole.
Mould stains: treat with bleach, rinse well
(whites and fast coloureds only).
Grass: soap lightly and treat with bleach
(whites and fast coloureds only).
Ball point pen and glue: moisten with ace-
tone
1)
, lay the garment on a soft cloth and
dab the stain.
Lipstick: moisten with acetone as above,
then treat stains with methylated spirits.
Treat any residual marks with bleach.
Red wine: soak in water and detergent,
rinse and treat with acetic or citric acid, then
rinse. Treat any residual marks with bleach.
Ink: depending on the type of ink, moisten
the fabric first with acetone
1)
, then with acetic
acid; treat any residual marks on white fab-
rics with bleach and then rinse thoroughly.
Tar stains: first treat with stain remover, me-
thylated spirits or benzine, then rub with de-
tergent paste.
Detergents and additives
Good washing results also depend on the
choice of detergent and use of the correct
1) do not use acetone on artificial silk
electrolux 13
Downloaded From WashingMachine-Manual.com Manuals