User manual

2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4.
Press button 8 .
At the end of the programme, turn the pro-
gramme selector dial to O to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
Stand by : once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display
is reduced. By pressing any button the ap-
pliance will come out of the energy saving
status.
Use - Drying
Drying only
Warning! Do not exceed the following
laundry loads:
• 5 kg for linen and cottons
• 3 kg for synthetics
Warning! The water tap must be
open and the drain hose must be
positioned in the sink or connected
to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin
speed allowed for the type of laundry in
order to obtain the best drying perform-
ances.
3. Select the drying programme for Cottons
or Synthetic in the Drying sector of the
programme selector dial.
4. If you wish to select an electronic drying,
depress the button 4 until the icon corre-
sponding to the required dryness degree
appears on the display, marked with the
icon
.
5. If you wish to select a timed drying, press
button 5 until the time you want appears
on the display (see the «Drying Pro-
grammes» table). Every time you press
this button the drying time increases by 5
minutes.
Note!
The programme time will automatically
increase by some minutes.
6. Press button 8 to start the programme.
After the programme has started, the
time remaining is updated every minute.
Note!
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning phase
may result in partial dryness. In the ex-
ceptional case that at the end of the cycle
the laundry remains slightly wet, we sug-
gest that you unfold the rolled up items,
redistribute them evenly in the drum and
select an additional drying cycle of 20-30
minutes.
7. At the end of the programme, the buzzer
sounds and three blinking « 0.00 » appear
on the display and the door is locked.
The last 10 minutes of the drying cycle
correspond to an anti-crease phase. Dur-
ing this time the door is locked and the
display keeps showing three flashing ze-
ros « 0.00 ».
If you wish to open the door before or
during the anti-crease phase or to inter-
rupt it, press any button or turn the pro-
gramme selector dial to any programme
position (except O ).
8. Turn the selector dial to the O position to
switch the machine off.
9. Remove the laundry.
Automatic washing and drying (NON-
STOP programme)
For NON-STOP programmes, it is also es-
sential not to exceed the maximum load sizes
of 5 kg for cotton and 3 kg for synthetics.
Caution! Do not use a dosing device/
ball when carrying out a washing
and drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the se-
lector dial to the selected washing pro-
gramme/fabric.
12 electrolux
Downloaded From WashingMachine-Manual.com Manuals