User manual
What to do if …56
What to do if …
If you are unable to remedy the problem by following the above sugges
tions, please contact your dealer or the Customer Care Department.
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch the oven on
The clock is not set Set the current time on the clock
The required settings have not
been set
Check the settings
The oven’s safety cutout has
been tripped
See “Safety fuse”
The fuse in the house’s electri
cal wiring (fuse box) has been
tripped
Check fuse. If the fuses trip repeat
edly, please call an authorised elec
trician
The oven lighting is not
operating
The oven bulb is faulty Change the oven bulb
The pyrolysis function is
not working (“C1“ is shown
in the time display)
Side rails/oven shelf runners
have not been removed
Remove side rails/oven shelf
runners
The oven does not heat up.
Time is lit
Demo mode is on Keep Selection button pressed
for 2 seconds, then within 2 sec
onds press and hold buttons Selec
tion and for 2 seconds
F11 appears in the clock
display
The meat probe has short
circuited or the plug of the
meat probe is not firmly in po
sition in the socket
Insert the plug of the meat probe as
far as it will go into the socket on
the side wall of the oven
F2 appears in the clock dis
play
Door not properly closed or
door lock defective
Close door properly;
Turn the appliance off and on again
via the house fuse or the safety
switch in the fuse box;
If displayed again, please contact
the Customer Care Department
An error code not listed
above appears in the time
display
Fault in the electronics Switch off the appliance via the
house fuse or the safety switch in
the fuse box and switch it on again
If displayed again, please contact
your local Service Force Centre