User manual

58
Cleaning the door glass panels
Clean the door glass panels thoroughly with a solution of water and
washing up liquid. Then dry them carefully.
Putting the door glass panels back.
1. From above insert the door glass
panels one after the other into the
door profile at the bottom edge of
the door at an angle and lower
them.
3 The two smaller panels first, then
the larger panel.
2. Take hold of the door trim (B) at
each side, position it on the inside
edge of the door and plug the door
trim (B) into the upper edge of the
door.
3 On the open side of the door
trim (B) there is a guide bar (C). This
must be pushed between the outer
door panel and the guide corner (D).
The clip seal (E) must be snapped in.