Product Info
(3) There is a serious drift during flight, or the aerial vehicle fails to fly in a straight line.。
Flight control of the aircraft
Take-off preparation
1. Check the battery level of the drone and the remote control, and charge them if the battery is low.
2. Check whether the propeller of the drone is tight and ensure that the blades are in the unfolded state.
3. Make sure that the remote control mode switch is in the middle position and the remote control is displayed as
"fixed point mode".
4.
Please check whether the compass data and attitude data are correct before flight. (Compass: when the drone is
still, the compass deviation angle of the remote control is within +/-2° and does not change. Attitude: raise one
side arm of the drone, and the remote control attitude display can change accordingly.); perform servo check,
and calibrate the joystick if any abnormality is found.
5.
Place the drone to the take-off point (with the power switched off), and ensure that the take-off point takes the
drone as the center of the circle for safety, without obstacles within a radius of 10 meters.
6.
Turn on the power switch of the drone. The drone is able to take off when the rear arm navigation light of the
drone is kept on in green and the remote control interface shows fixed point mode.
7. Try to avoid starting two drones at close range simultaneously to prevent accidents.
8.
Ensure that both the video antenna and the radio antenna are installed correctly before the flight, to avoid
affecting the flight and video receiving distance or causing damage to the transmitting module inside the drone
and remote controller.
Start the drone
1.
Place the aircraft on an open horizontal surface, connect the power, turn the power switch to ON, and start up the aircraft
to the satellite positioning state.(The tail light of the aircraft is red during the satellite positioning, and will be green after
the successful satellite positioning);
2.
Press the remote control for 1S, then press and hold the power button to turn it on. The remote control will automatically
enter the GS software and the interface. Click to enter the device, and after the enterance, the remote control will display
the status of the aircraft (such as satellite intensity, speed, altitude, distance, latitude and longitude).
3.
Manual take-off. Under the condition of successful satellite positioning of the aircraft (the tail light of the aircraft is
green), switch the remote control mode to the fixed point mode (middle position), make the remote control joystick
perform the "down splayed" operation. Then the aircraft is unlocked, and the blades start rotating. When it enters into
the idle state, release the joystick to the center, make the left joystick slowly push the throttle, then the motor of the
aircraft accelerates and the aircraft will slowly rise. As shown below:
Middle position: fixed point mode
A
AEE Unmanned Aircraft System
Professional Leading