User Manual

7
aee.com
7
1.3 Quadcopter Battery Installation
Push the battery into the battery compartment in the correct direction (Figure 7). After the battery is properly installed, a “click” sound will be heard, indicating that the
battery has been fastened.
Figure 7
1.4 Quadcopter Propeller Guard Attachment Instructions
Please follow the below instructions to attach your Quadcopter Propeller Guards.
(1) Gather together the Quadcopter Propeller Guards (4) PM3x10 Screws (8), Screwdriver.
(2) Remove the PM3x6 Screws under each of the four motors (Figure.a).
(3) Place the Propeller Guards and attach them with the PM3x10 screws (Figure.b). Tighten as required . Do this for all four Propeller Guards. Do not use thread
lock.
(4) Assembly complete(Figure.c)
(5) Replace back PM3X6 (8) screws on the four motors after remove the Propeller Guards.
IMPORTANT: PM3x10 screw is only for Propeller Guards assembly. Without a Propeller Guards, use PM3x6 screw to avoid damaging the motor.
Figure.a Removing Screws Figure.b Prop Guard Attachment Figure.c Complete
1.5 Caution
(1) Do not directly pull out the battery when the Quadcopter is switched on as it may damage the power supply connector.
(2) For long term storage, discharge the battery to 40%-50% power, and store in a specied battery box. Discharge/charge the battery once every three months to
maintain battery life.
(3) Replace the battery after it has been discharged over 300 times. Completely discharge a battery prior to disposal.
(4) Replace the battery if your current battery swells up or is damaged in any way, to avoid re and explosion.
(5) Do not charge expanded or damaged batteries.
(6) Please pay attention to the battery charging process in order to avoid accidents, and make sure there are no ammable or combustible materials around the
battery and the charger.
(7) Battery safety is extremely important. Please refer to Disclaimer for more precautions.
2 Preparing the Quadcopter
The Quadcopter consists mainly of the ight control system, gimbal, camera (optional) and power unit.
2.1 Introduction
An incorrectly installed battery may
cause
● Bad contact
● Affect ight safety
● Inability to take off.