User Manual
21
aee.com
21
1 2 3 4 5
S4
GPS
NRM
F M
After the quadcopter powers
on(about 20 seconds). Swich S4
for more than 5 times between
GPS and Follow Me mode. The
quadcopter will enter calibraion
standby mode(the tail light blinks
fast).
Toggle the joysticks to the
position as in the follow figure.
Front indicator (green) starts
blinking ,Then release the
joysticks.Compass calibration
command has been sent
successfully.
Rotate Quadcopter 360°
horizontally
(2 turns)
Rotate Quadcopter 360°
vertically
2 turns (Nose down )
Rotate Quadcopter vertically (Nose
leftward)until green lights off, Put
Quadcopter on the ground. Green
lights up normally after light off→
calibration successful; Green lights
blink fast after light off→calibration
failed →Recalibrate
Warning
Be sure to remove propellers before calibration, to avoid accidental injury or loss.
1.2 When to Recalibrate
(1) When compass data is abnormal, front indicator (green) blinks fast.
(2) The ight location is far from the place where last compass calibration was conducted.
(3) There are changes in quadcopter’s physical structure.
(4) The quadcopter drifts a lot while ying , such as it ies along a circle when hovering.
2 Starting / Stopping the Motor
2.1 Starting the motor
Toggle the joysticks as shown in the illustration (Combination joystick Command [CSC]) to start the motor. Release the joysticks simultaneously after the motors
start.
T
oggle Left joystick to left bottom corner
T
oggle Right joystick to right bottom corner
GPS
NRM
S1 S2 S3 S4
GPS
NRM
D
F M
S
E
S1
D
S
E
S1: E S2: OK S3: Middle S4: GPS
S2
S3
S4
NULL
NULL
When S4 switch is set to GPS Mode,
S4
The motor cannot be turned on until GPS is ready (Tail
indicator will alternate between fast blinking and on).
Figure 20
2.2 Stopping the Motors
There are two ways to stop the motors.
Method One (Figure 21):
After the quadcopter lands, toggle the throttle joystick to the lowest position and then perform CSC, the motors will immediately
stop. Release both joysticks after the motors stop.
Method 2 (Figure 22):
After the quadcopter lands, toggle the left joystick to the lowest position and hold for 3 seconds to stop the motor.
Figure 21 Figure 22