User Manual

17
aee.com
17
[ 2 ] Power indicator Power indicator is red
[ 3 ] Statu indicator Status indicator is green
[ 4 ] Contacts Charging contacts.
※
Note:
1. Code pairing process: turn on the tracker and trigger its code pairing function; turn on the quadcopter, and its built-in 5.8GHz module will auto proceed with the
code pairing process. In the code pairing process, the distance between the tracker and quadcopter should be less than 10m.
2. After the code pairing function is triggered, the tracker will auto exit the code pairing state if the code pairing process is nished successfully within 30s. If no code
pairing device is found or the code pairing process fails within 30s, the tracker will also auto exit the code pairing function.
6.3 Indicators on the tracker
SN Status Red indicator Green indicator Notes
1 During startup process ON
Green indicator blinks after 3
seconds
Press and hold the Power button until the red indicator
is lit. After 3 seconds, the green indicator starts blinking,
indicating the startup is completed.
2
During shutdown
process
Red indicator goes out
after 3 seconds
OFF
Press and hold the Power button until the green indicator
goes out. After 3 seconds, the red indicator goes out,
indicating the shutdown is completed.
3 No device to pair with / Blinking fast Blinking 10 times per second
4 During code-pairing / Blinking fast Blinking 5 times per second
5 Searching GPS signal / Indicator’s blinking sequence 1 Remaining on → blinking fast for 3 times
6 GPS signals are OK / Green indicator remains on
7 Abnormal system / Green indicator goes out Restarting is required
8 Charging battery Blinking slowly / Blinking 1 times per second
9 Battery charged fully Remaining on /
10 Low battery power Blinking fast / Blinking 10 times per second
6.4 Operating Instructions
6.4.1 Operating Steps:
Component Startup Time
Turn
on the
quad-
copter
Start
the APP
on the
mobile
device
Perform
the takeoff
operation of
the quadcopter
Turn the mode
switch of the
remote control to
“F-M”
The quadcopter
will enter the
follow-me video
recording mode.
Camera 20s
Repeater 22s
Remote control 10s
Tracker 10s
6.4.2 Follow-me Video Recording:
1. Start the video recording mode: the quadcopter will auto adjust the ight altitude to 10m and y horizontally to the position 15m away from the tracker.
2. In the Follow-me : the camera lens on the quadcopter will always face the GT10 wearer.
3. When the GT10 wearer moves forward or backward, the quadcopter will follow him to y forward or backward.
4. If the GT10 wearer stays still, the quadcopter will hover.
5. When the GT10 wearer ascends or descends, the quadcopter will follow him to ascend or descend.
6.4.3 Working Conditions:
1. Use the Tracker in an open and accessible area only.
2. The GT10 wearer should not move at a speed exceeding 10m/s, or the quadcopter will enter the out-of-control mode. In such case, please use the mode
switch on the remote control to switch the mode.
6.4.4 How to Enter Follow me Mode
※
Case 1: in power-off status, when you turn on the quadcopter and repeater, and turn S4 mode switch to “F_M mode”, the quadcopter will not enter the Follow
me mode.
※
Case 2: if the quadcopter is ying at a distance ≤100m away from the tracker (the tracker has been connected to the quadcopter), when you turn S4 mode
switch to “F_M mode”, the quadcopter will take the shortest route to auto y to the position 10m over the ground and 15m away from the tracker, and make