Use and Care Manual

Thanks for choosing our product. Please kindly check parts listed below and read this manual

carefully, then assemble them step by step. Please feel free to contact us for any questions.

Steel Umbrella Side Table

ASSEMBLY INSTRUCTIONS SS16085

Attention

1. If there is any part missing, please kindly send us messages to let us know the name of

missing part regarding to the first page of instructions. We will send replacement to you asap.

2. If there is any damage, please send clear photos about damaged part to us as attachment,

we will check and offer you best solution soon.

3. We are concerned about each customer's experience, if there is any loss or damage, please

PAGE 1
ASSEMBLY INSTRUCTIONS SS16085 Steel Umbrella Side Table Thanks for choosing our product. Please kindly check parts listed below and read this manual carefully, then assemble them step by step. Please feel free to contact us for any questions. Attention 1. If there is any part missing, please kindly send us messages to let us know the name of missing part regarding to the first page of instructions. We will send replacement to you asap. 2.
PAGE 2
Parts List A X1 B X2 Table top D X1 Bottom panel H X3 M6*20 Screw C X2 Side panel G X8 Table leg F X1 E X1 Umbrella base pole Plastic umbrella ring I X8 J X19 M6*32 Screw M6*15 Screw K X1 Washer Allen wrench Assembly Instruction_16085 STEP1 D H H H H J J J J M6×20mm 3× 3× * Connect Bottom Panel [ D ] to Umbrella Base Pole [ E ] with Screw [ H ] and Washer [ J ] by Allen Wrench [ K ].
PAGE 3
Assembly Instruction_16085 STEP2 * Insert Table Leg [ B ] to Table Top [ A ] with Screw [ G ] and Washer [ J ] by Allen Wrench [ K ]. G J M6×15mm 4× 4× G B J A STEP3 I J C B I J A M6×32mm 8× 8× * Connect Side Panel [ C ] to Table Leg [ B ] with Screw [ I ] and Wrench [ J ] by Allen Wrench.
PAGE 4
Assembly Instruction_16085 STEP4 * Connect Bottom Panel [ D ] to Table Leg [ B ] and Side Panel [ C ] with Screw [ G ] and Wrench [ J ] by Allen Wrench. G M6×15mm 4× J 4× G J D STEP5 F F E * Note: The opening of the Plastic Umbrella Ring [ F ] should be aligned with the steel plate in the Umbrella Base Pole .