Specifications

Peripherals
©2002 Bally Gaming and Systems 8-43 Peripherals
NOITIDNOC DELSUTATS DELRREE
ffOderewoPnitinUFF0FF0
ydaeRtinUNOFFO
dehsulFtinUNONO
tuorepaPFFONO
pUdaeHFFONO
rorrEerutarepmeTFFOKNILBDEM
rorrEegatloVFFOKNILBWOLS
rorrEdaeHtnirPNOKNILBTSAF
rorrEyromeMhsalFKNILBWOLSKNILBDEM
wolfrevOreffuBFFOKNILBTSAF
kraMxednIkcalBgnissiMNOKNILBTSAF
maJrepaPNOKNILBTSAF
Keypad LED Operation
The following table lists the conditions reported by the
keypad LEDs.
Error Conditions
Paper Out: The printer detects that paper is not present.
The printer scans for a paper-out condition at all times.
Remedy by loading a new paper stack.
Head Up: This condition results from lowering the Platen
Release Lever. To remedy, raise the blue lever on the
side of the unit.
Temperature Error: The printer has overheated. If the
printer is operating environment is at room-temperature,
this error would most likely be the result of a hardware
problem. The printer will automatically resume opera-
tion when the head temperature cools within operational
limits.
Voltage Error: The printer detected a power supply volt-
age (+24VDC to +25VDC) outside of legal limits. The
printer will automatically resume operation when the
power supply is within range.
Print Head Error: The printer senses an interfacing prob-
lem with the thermal print head. The error state remains
until the power is cycled or the unit is reset. If the prob-
lem persists, the printer will require service.
Flash Memory Error: The printer is unable to program
the Flash memory on the board. The printer will remain
in error state until the power is cycled or the unit is reset.
If the problem persists, the printer will require service
before font or graphic data can be downloaded.
Buffer Overflow: A buffer overflow typically results from
a mismatch in handshaking. The printer will remain in
error state until the power is cycled or the unit is reset.
Ticket Printers (cont.)
Missing Index Mark: While feeding paper or while
printing, a black mark has not been seen within
approximately 10” of paper. Remedy by using the correct
paper in the printer, or installing the paper in the correct
orientation. The condition is removed by raising the
Platen Release Lever (presumably to change the paper).
Paper Jam: The printer detected an obstruction in the
paper path. Remedy by opening the printer head and
inspecting for a jammed ticket.
Self Test: If the Keypad FEED is held during power on
or reset, a self test will be triggered. Proper operation
will result in the printing of a configuration ticket.
Model: PSA-66-ST
Firmware: 1.0.0.0.0
COMMUNICATION
Interface: serial
Baud Rate: 19200
Data Bits: 8
Parity: NONE
Handshaking: HARDWARE
PRINT CONTROL
Darkness Control:+00%
Black Bar Index: Disabled
Print On Demand: Disabled
Auto Sleep Timer:Off
SYSTEM RESOURCES
FLASH -Used: 000000
-Free: 024064
LIBRARY INVENTORY
Templates:
Print Regions:
Graphics:
Fonts: 3(0), 7(0), 8(0), 5(0)
Sample Self-Test Ticket