Specifications

Peripherals

Ticket Printers (cont.)

8. The receipt and journal thread through different paths.

Using the Thumb Wheel ( Gear on the left side. See

bottom figure) to advance the paper, guide the journal

and receipt paper so that they are separated by the

Shear Plate.

9. Advance about six inches of paper then tear off only

the white receipt ply.

10. Reassemble the Journal Takeup Spindle by turning

the flange in the direction of the

ON arrow. Do not

overtighten.

11. Fold about ½” of the journal paper and insert it into

the groove of the Journal Takeup Spindle so that the

gear is to the right.

12. Turn the Journal Takeup Spindle a few turns in the

direction of the ON arrow to take up the excess jour-

nal paper.

Replacing the Printhead

1. Remove the ribbon cassette.

2. Release the printhead by unfastening the Printhead

Clamp. Pull the tab on the left to swing it open.

3. Hold down the Cutter Blade Cover.

4. Pull the printhead free from the edge connecter and

carriage.

5. Using the guide on the printhead, slide the new

printhead onto the carriage and into the edge con-

nector.

Function Switch

The Function Switch is

a momentary two-posi-

tion switch that provides

the following functions:

With power ON:

Left: Incremental paper

advance

Right: Auto paper ad-

vance and cut.

Position switch with

power OFF, then power ON:

Left: Print Test

Right: Hex Data Dump

WARNING: The printhead may be hot.