Specifications

Peripherals 8-38 ©2002 Bally Gaming and Systems
noitpircseD #traP
)ylp-owt(repaP8550-89
)elprupkradrokcalb(ettessaCnobbiR )21foesac(0650-60
retemaiDegraLeldnipSlloRylppuS0321-90
retemaiDllamSeldnipSlloRylppuS4941-90
eroCpu-ekaTeldnipSpu-ekaT7950-60
egnalFpu-ekaT9950-60
)egnalfdnaerochtob(ylbmessApu-ekaT3990-60
droCrewoP1650-60
tloV521,pmA0.1sesuF0100189-051
tloV521,pmA5.15100189-051
daehtnirP5650-60
pmalCdaehtnirP1750-60
Ordering Supplies
The following parts are available through TransAct Tech-
nologies, Inc.:
Ticket Printers (cont.)
Changing Paper
Change the Supply Roll paper when you see the pink
stripe on the receipt paper or when the terminal indi-
cates the paper is low. Although the pink stripe appears
with eight to ten feet left on the roll, the printer will print
only 21 inches after the Paper Low sensor activates.
1. Unsnap the Journal Takeup Roll Spindle from the
bracket. Tear off the yellow journal paper using the
Shear Plate.
2. Remove the spindle from the journal by unscrewing
the left flange in the direction of the
OFF arrow. Se-
cure and store the journal roll as required.
3. Unsnap the Supply Roll Spindle from the bracket. Hold
down the Cutter Blade Cover and pull the remaining
paper out of the printer.
4. Remove the spindle from the used supply roll and
set it aside. Don’t throw it away.
5. Trim enough of the new Supply Roll for a straight edge
free from glue.
6. Put the spindle that was removed from the used sup-
ply roll into the new roll so that the white receipt pa-
per is on the outside (See figure below). Snap the
spindle into the lower set of snaps in the Bucket.
7. Hold down the Cuter Blade Cover and push the pa-
per up through the throat in the back of the Bucket
until the paper passes the printhead.