Specifications

Peripherals 8-22 ©2002 Bally Gaming and Systems
Bill Acceptors (cont.)
ZT1200. Boot mode is a special mode, which is reserved
for factory use and field software upgrades. This unit
will not accept bills or give credits when in this mode. To
exit Boot mode, return the mode switch to the Interface
mode position.
Test Mode: The test mode allows testing of the unit
without credits being communicated to the host machine.
This mode is very useful for troubleshooting and other
stand-alone testing of the bill acceptor.
Entering the Test Mode:
1. Power up the ZT1200 in Interface mode.
2. After the unit performs a run-and-stack operation,
wait at least an additional 10 seconds before
performing the next step.
3. Hold the mode switch in test mode position.
The ZT1200 will now accept and stack bills, but no
credits will be issued on the host machine.
To Exit the Test Mode:
1. Release the mode switch and return it to the Interface
mode position.
2. Remove the RTU.
3. Replace the RTU (the unit will perform a run-and-stack.
The unit is now ready for use.
Coupon Mode: This mode is selected by toggling the
mode switch to the up position. This mode allows the
default settings to be changed in the ZT1200 bill
acceptor. These settings are used when switches 1-7
are in the
OFF position on the bill option switch. The
factory default coupon settings are $1, $2, $5, $10, $20,
$50, and $100s enabled with four-way acceptance.
Coupon mode will only allow a onetime try for coupon
configuration. After an attempt, the ZT1200 will
automatically return to Interface mode.
1. Turn bill option switches 1-7 to the off position.
2. To enter the coupon mode, toggle the mode switch
to the up position one time.
3. Install the RTU into the machine and close the door.
The unit will run-and-stack and then pulse the motor
in reverse indicating coupon configuration mode is
enabled.
Coupon Configuration:
1. Make copies of a coupon with a standard, carbon-
based, non-color copier. Copies of the coupon are
usable if cut to match the size of the following coupon.
2. Fill out the coupon using a #2 pencil to complete the
blocks for desired coupons. For correct operation,
all eight lines must be completed. Fill in only one
block per line. Do not mark the back of the coupon.
3. Complete lines one through seven to enable desired
bill denominations. Complete one block for each
denomination. High accept enables maximum bill
acceptance. High security may be desired for locations
where a higher level of discrimination is desired. Off
will reject bills of the selected denomination.
4. Complete line eight to enable desired bill direction.
Enable 1-or 2-way face up, or 4-way acceptance
(which allows acceptance in all directions).
5. Insert coupon and verify settings were accepted.
ACCEPTED: Coupon will be held in escrow mode for
approximately three seconds then
returned.
REJECTED: Coupon will be immediately returned.
Review instructions or try a new coupon.
Returning to Normal Operation:
1. Remove the RTU.
2. Change bill option switches.
3. Reinstall the RTU.
Calibration:
NOTE: Bills will be accepted, but credits
will not be given in test mode. Ensure
that test mode is properly exited before
placing the bill acceptor back in service.
NOTE: The cashbox must be in place for
bill acceptance.
NOTE: A Mars ZT Calibration Kit is
required to perform a calibration. Contact
Mars at [phone] and reference
part number 251061008 for assistance.