Specifications

Programming and Operating 4
SHM80001
SAFETY HI-TECH
Quaestor-SZU Releasing Fire Control Panel - Installation and Operation Manual
Revision E03.04
38 of 155
This section describes programming and operating the Quaestor-SZU Releasing Fire Control Panel.
Programming the Fire Control Panel
The Quaestor-SZU Releasing Fire Control Panel can be configured for almost any installation requirement.
Navigate the menu on the System Mode LED display using the Select and Enter buttons of the Quaestor-SZU
Releasing Fire Control Panel. The System Mode LED, Select and Enter buttons are located in the center of the
front-panel fascia. Program the Quaestor-SZU Releasing Fire Control Panel in Access Level 3.
Access Level 3
To program the fire control panel in Access Level 3:
The figure below illustrates the Write Enable switch on the fascia of the Quaestor-SZU Releasing Fire Control Panel:
Figure 3-1
Write Enable Switch
1
Set Access Level 2 by turning the Enable Access key to the right.
2 Move the Write Enable slide-switch to the right.
The fire control panel beeps three-times to indicate entry in Access Level 3.
The beeping continues while in Access Level 3.
4 Press Mode and Select on the fascia to scroll through codes of the System Mode LED.
Terminate
Release
W/Dog
Reset
Processor
Reset
Exting.
Mon.
Write
Enable
Section 4
Programming and Operating