Specifications

Overview 2
SHM80001
SAFETY HI-TECH
Quaestor-SZU Releasing Fire Control Panel - Installation and Operation Manual
Revision E03.04
12 of 155
Lower Controls
The figure below illustrates the lower controls of the Quaestor-SZU Releasing Fire Control Panel:
Figure 2-6
Lower Controls
The table below describes lower controls of the Quaestor-SZU Releasing Fire Control Panel:
Indicators
The front-panel of the Quaestor-SZU Releasing Fire Control Panel provides upper, central and lower indicators.
Upper Indicators
The figure below illustrates upper indicators of the Quaestor-SZU Releasing Fire Control Panel:
Figure 2-7
Upper Indicators
Lower Controls Modes
Terminate Release
Terminates the flow of extinguishant caused by a releasing event and resets the
operation of the fire control panel.
W / Dog Reset
Clears the watchdog event caused when the fire control panel failed to carry out
an operation.
Processor Reset
Resets processors and restores operation of the fire control panel. This function
is also used to re-initialize the processors following a firmware upgrade.
Exting. Mon.
Potentiometer for calibrating the releasing circuit of the fire control panel.
Write Enable
Slide-switch used in conjunction with the Enable Access switch to configure the
fire control panel in Access Level 3.
Terminate
Release
W/Dog
Reset
Processor
Reset
Exting.
Mon.
Write
Enable
On Test/Disabled
Test Mode On
General
Disablement
System Trouble
Buzzer Silenced
2nd Stage Output
Extract Fan On
Abort Activated
Releasing Trouble
Power On
General System Status Fire In Zone
123
Zone Trouble/
Disablements/
Supervisory
Releasing Status
Fire
Delay On
NAC Trouble/
Disabled
Power Trouble
General Trouble
Manual Release
Extinguishant
1st Stage Output
Release
Imminent
Auto &
Manual
Manual
Only
Extinguishant
Released
Low
Pressue
1st Stage
Activated