Specifications

Printed in the U.S.A.

AE8-1368 R2

14.0 Installation of the compressor (6D)

1. Mount the new compressor in the rack, lifting

and maneuvering the compressor in a manner to

prevent personal injury and damage to the other

compressors on the rack.

2. Transfer the temperature sensor and pressure

control ﬁ ttings to the head and body of the new

compressor. Use of a thread sealing compound is

recommended.

3. Install high pressure cutout switch (RED DOT

- 360 psi) on the head, and low pressure cutout

switch (WHITE DOT - 3 psi) on the compressor

body. Double Check Positions!

4. Install the terminal box on the compressor. Secure

to the compressor using the four anchor screws.

5. Inside the terminal box

• Connect compressor power terminal lugs

• Connect terminal box grounding strap

• Connect motor sensor leads

• Connect the compressor voltage sensing leads

6. Reconnect the pressure controls to wiring harness

(HPCO-RED leads and LPCO-BLUE leads).

7. Reinstall the side cover and control module as an

assembly. Fasten to compressor with mounting

nuts (6x).

Figure 7.6 – 6D Terminal Box Connections

Figure 7.5

6D CoreSense Diagnostics v2.11 Assembly Reference Drawing

8. Reconnect all plugs at the control module including

the RS-485 communications plug.

9. Reconnect the harness to the oil pressure sensor.

10. Reconnect the harness to the head temperature

probe and unloaders (if present).

11. Replace the terminal box cover and secure with

two screws.

12. Reinstall the control module access cover and

secure with two screws.

13. Apply power to the compressor and CoreSense

Diagnostics

modules.