INSTRUCTION MANUAL CONTROL LOCATIONS TRANSMITTER i LED Indicator (Power ON) 2} Power OFF Switch and Chan net Selector 3 AUDIO IN Jack (1 Connect to Music Source 4 DIO IN Jack (R} Connect to Music Source 3} DC Input Jack SPEAKER 6) Frequency Channel Selector 7} Tone Control Knob 8) Power OFF and Volume Conspire Knob 6 DC Input frack MODE Switch (To Select Left/ Mono or Right Channel] Battery Compartment
Tc ARTURO “You need to properly set up the Transmitter to send a wireless signal to. the Speakers. There are two things you must do. First, provide power to the Transmitter, and second, correct the Transmitter to the Audio Source. 1) CONNECTING POWER {A} DC OPERATION Your Transmitter is supplied with a Battery Compartment. Insert four x AA Alkaline ’ batteries (not supplied) to the battery slot as indicated. Attach the battery compartment of? J] Battery cover to fhe bottom of the Transmitter unit.
INSTALLING A SPEAKER CONNECTING POWER {A} DC OPERATION (with optional BP200SP Lottery Pack sold on page 11} + Open the battery cover located at the back of Speaker © the Speaker unit. Insert the battery making Unit sure the side with the contacts (located on EN the top edge) is inserted to make contact i with the coil springs inside the compartment men. Push the battery all the way in until J. you feel resistance from the coil springs’ inside the compartment.
OPERATION Follow these steps to obtain maximum listening performance 1) Make sure that your Transmitter and Speakers are set up according to the procedures given in this manual. 2) Tun on your Audio Source. 3) Switch the Transmitter to a Frequency Channel (Channel 1, OF 2) that has no interference. ¥ Refer to CHANNEL SELECT below for Precision Frequency Lock-In Tuning. ! 4) Rotate the CHANNEL Knob on the front of the Speakers to select the § same channel (Channel 1, or 2) selected on the Transmitter.
USER MANUAL INSERTS FOR PART 15 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could cold the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
