User's Manual

GETTING STARTEDGETTING STARTED
INSTALLATION
4
v Follow these steps to install the monitor
1. Before you connect the cables, make sure the monitor and system
unit power switches are OFF.
2. Plug the 15-pin signal cable or 24-pin DVI Cable between the rear of
your Monitor and system. The adapter may be required for certain Apple
Macintosh computers. Tighten the two screws on the cable connector.
3. Plug the Audio Cable between Audio input Jack in the rear of your
monitor and audio output of your system.
4. Plug the USB Cable between USB Hub which is in the bottom of your
monitor and your system
5. Connect the power cord to the inlet socket which is located at the
AC Adapter. Connect the plug into an AC wall outlet.
6. Connect DC Plug of AC Adapter to the DC Jack which is located at the
rear of your monitor.