User's Manual

GETTING STARTEDGETTING STARTED

INSTALLATION

v Follow these steps to install the monitor

1. Before you connect the cables, make sure the monitor and system

unit power switches are OFF.

2. Plug the 15-pin signal cable between the rear of your Monitor and

system. The adapter may be required for certain Apple Macintosh

computers. Tighten the two screws on the cable connector.

3. Plug the Audio Cable between Audio input Jack in the rear of your

monitor and audio output of your system.

4. Connect the power cord to the inlet socket which is located at the

AC Adapter. Connect the plug into an AC wall outlet.

5. Connect DC Plug of AC Adapter to the DC Jack which is located at the

rear of your monitor.