User's Manual

GETTING STARTEDGETTING STARTED
GETTING STARTED
GETTING STARTED
CONTROL BUTTONS
5
INSTALLATION
4
" Follow these steps to install the monitor
1. Before you connect the cables, make sure the monitor and system
unit power switches are OFF.
2. Plug the 15-pin signal cable between the rear of your Monitor and
system. The adapter may be required for certain Apple Macintosh
computers. Tighten the two screws on the cable connector.
3. Plug the Audio Cable between Audio input Jack in the rear of your
monitor and audio output of your system.
4. Connect the power cord to the inlet socket which is located at the
AC Adapter. Connect the plug into an AC wall outlet.
5. Connect DC Plug of AC Adapter to the DC Jack which is located at the
rear of your monitor.
OSD Buttons : The OSD control keys are located on lower left of the
monitor.
((EEnntteerr))
a. No OSD : This button will enable the main OSD menu.
b. Main OSD menu : Press this button to enter to the selected OSD
control menu.
c. Cotrol OSD menu : Swap the control item.
oorr ((UUpp//DDoowwnn))
: Use these buttons to increase or decrease each value.
a. No OSD : : Audio volume control menu will be shown.
b. Main OSD menu : Use these button to move up (or down)the OSD
selection menu and adjust the attribute of the monitor while in OSD
mode.
((AAuuttoo))
: No OSD : This button can be used to 'Auto Adjustment' function.
(Size, Phase, and Color)