User`s manual

13
Description:
This chapter covers the network parameters configuration of VP-16.
The VP-16 factory default user name is “admin,” password is “12345.”
The VP-16 factory default IP address is 192.0.0.64.
The network parameters need to be set up before the decoding channel configuration. The network
parameters are used to connect with the software, which is applied to set the decoding channels. The
network parameters include IP address, subnet mask, gateway and port.
3.1 Hyper Terminal Setup
The common method is to connect decoder and PC with serial line, run Hyper Terminal and modify
parameters with serial command. Please connect the RS-232 port of decoder directly to the COM port of
PC, power on the decoder and PC and follow the steps:
Step 1: Enter Hyper Terminal.
Click “Start”-> “Programs”->” Accessories”-> “Communications”-> “Hyper Terminal” in Windows system,
and the dialogue box below will appear as in Figure 3.1.1.
Step 2: Name the connection and define the icon.
Input a name (e.g. VI), select an icon, and press “OK” to enter “Connect To” dialogue box.
Step 3: Select the communication port.
Select “COM1” in “Connect To” interface (Please select the COM port according to the reality, in case
PC has more than 1 COM.). Press “OK” to enter “Properties” dialogue box.