User manual

58
Chapter 9: Log Search and
Maintenance
9.1 Log Search
Purpose
The operation, alarm, exception and information of the device can be stored in log files, which can be
viewed and exported at any time.
Before you start
The Log function can be realized only when the Encoder is connected with HDD (for VP-4HFI/HCI-SATA)
or network disk. And make sure the HDD or network disk has been initialized for the first time to use.
Please refer to Section 6.3.5 Adding Network Disk for details.
Steps:
1. Click Log on the menu bar to enter the Log interface.
2. Set the log search conditions to refine your search, including the Major Type, Minor Type, Start Time
and End Time.
3. Click the Search button to start searching log files.
4. The matched log files will be displayed on the list shown below.
Note: Up to 100 log files can be displayed each time.
Figure 9.1 Log Search Interface
5. You can click the button to save the searched log files to local directory.