User manual

47
screen monitoring” will be displayed in full screen.
 Audio Warning
Trigger an audible beep when an alarm is detected.
 Notify Surveillance Center
Send an exception or alarm signal to remote alarm host when an event occurs. The alarm host
refers to the PC installed with Remote Client.
 Send Email
Send an email with alarm information to a user or users when an event occurs.
Note: To send the Email when an event occurs, you need to go to the network setting interface
to set the related parameters. Refer to Section6.3.4 Configuring Email Settings.
(3) Select the channel you want to trigger an external alarm output when a motion detection event
occurs.
Figure 7.14 Motion Detection-Trigger Alarm Output
Note: To trigger an external alarm output when an event occurs, you need to go to the Alarm
Output Settings interface to set the related parameters.
1) Click Remote Configuration> Alarm Settings> Alarm Output to enter the Alarm
Output Settings interface.
Figure 7.15 Motion Detection-Alarm Output Settings
2) Select one alarm output channel in the Alarm Output drop-down list.
3) The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or Manual.
The Delay refers to the time duration that the alarm output remains in effect after alarm
occurs.
Note: If you choose Manual, you need to manually disable the alarm output.