User manual

36
4. Click Save to save the Email settings.
Please refer to the following sections for more information:
 Configuring alarm linking method with Send Email on Section 7.3.1 Configuring Motion Detection.
 Configuring alarm linking method with Send Email on Section 7.3.2 Configuring External Alarm
Input.
 Configuring alarm linking method with Send Email on Section 7.3.3 Configuring Video Loss Alarm.
 Configuring alarm linking method with Send Email on Section 7.3.4 Configuring Tamper-proof Alarm.
 Configuring alarm linking method with Send Email on Section 7.3.5 Handling Exception.
6.3.5 Adding Network Disk
For VP-4HCI/HFI models, you should configure the network disk before operating the recording,
playback or log searching. For other models with SATA disks connected, the configuration of network disk
is selectable.
Before you start:
1. The network storage device is available within the network and is properly connected.
2. The network storage device is configured with NAS or IP SAN mode (please refer to the User
Manual of IP SAN/NAS).
Steps:
1. Click Remote Configuration > Network Settings >NetHDD Settings to enter the NetHDD
Settings interface.
Figure 6.17 Network Disk Settings
2. Enter the IP address of the Network Storage System and File Path in the text filed.
3. Select the type of Network Storage System to IP SAN or NAS.
NAS Mode: Enter the IP address of the storage device, and the default file path is /dvr/share, in
which the share name is user-defined during creating the DVR of the network storage.
IP SAN mode: Enter the IP address of the storage device, and the default file path is
iqn.2004-05.storos.t-service ID, in which the service ID is user-defined during creating the iSCSI
volume of the network storage.
4. Click the Save button to add the configured network disk.
5. Initialize the added network disk.
(1) Click Remote Configuration > HDD Management to enter the HDD settings menu, on which you