User manual

synchronization function, such as the server at the National Time Center (IP Address: 210.72.145.44). If

the device is set up in a more customized network, NTP software can be used to establish a NTP server

used for time synchronization.

 Configuring Time Synchronization by Manually

Enable the Manual Time Sync function and then click the icon to set the system time from the

pop-up calendar. You can check the checkbox of Snyc with local time to synchronize the time with the

local PC.

Figure 6.5 Time Sync by Manually

4. Configure DST settings if needed.

Figure 6.6 Set DST

(1) Check the checkbox before the Enable DST.

(2) Set the start tine and end time of DST period. The end time must be later than the start time. When

the DST period ends, the system will reverts to the standard local time.

(3) Set the DST bias to 30min, 60min, 90min or 120min.

5. Click the Save button to save the settings.

6.3 Network Settings

6.3.1 Configuring Basic Settings

Network settings must be properly configured before you operate device over network.

Steps:

1. Click the Remote Configuration > Network Settings > Basic Settings to enter the Basic Network

Settings interface: