User manual

Advidia A200 User Manual
32 32
 PTZ OSD: Set the on-screen display duration of the PTZ status.
-Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5
seconds, 10 seconds, Always Close or Always Open.
-PT Status: Set the azimuth angle display duration while panning and
tilting as 2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
-Preset Status: Set the preset name display duration while calling the
preset as 2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Power-off Memory: The dome can resume its previous PTZ status or actions
after it restarted from a power-off. You can set the time point of which the
dome resumes its PTZ status. You can set it to resume the status of 30
seconds, 60 seconds, 300 seconds or 600 seconds before power-off.
3. Click to save the settings.
5.3 Configuring PTZ Stop Limits
Purpose:
The dome can be programmed to move within the configurable limits (left/right,
up/down).
Steps:
1. Enter the Limit Configuration interface:
Configuration > Advanced Configuration > PTZ > Limit
Figure 5-3 Configure the PTZ Limit