User manual

Advidia A200 User Manual
12
Chapter 2 Network Connection
Before you start:
*If you want to set the network speed dome via a LAN (Local Area Network), please
refer to Section 2.1 Setting the Network Speed Dome over the LAN.
*If you want to set the network speed dome via a WAN (Wide Area Network), please
refer to Section 2.2 Setting the Network Speed Dome over the WAN.
2.1 Setting the Network Speed Dome over the LAN
Purpose:
To view and configure the speed dome via a LAN, you need to connect the network
speed dome in the same subnet with your computer, and install the Advidia Camera
Finder Utility (download at www.downloadvi.com) to search and change the IP of the
network speed dome.
*Note: For the detailed introduction of Advidia Camera Finder Utility, please refer to
Appendix 1.
2.1.1 Wiring over the LAN
The following figures show the two ways of cable connection of an Advidia A200
Network Speed Dome and a computer:
Purpose:
 To test the network speed dome, you can directly connect the network speed
dome to the computer with a network cable as shown in Figure 2-1.
 Refer to the Figure 2-2 to set the network speed dome over the LAN via a
switch or a router.
Figure 2-1 Connecting Directly
Network Cable