Assembly Instructions

PG 4
Brace 1
Brace 3
Brace 2
Deck
Screws
Assembly Instructions
1) Attach braces to the inside of the stringers using at least 2 deck
screws at each connection. Brace 1 and Brace 2 should be installed
rst. Using the level, ensure that Brace 1 and Brace 2 are level with
the ground. Note: The face of Brace 1 should align with your tree
as seen in the graphic to the right.
2) Once Brace 1 and Brace 2 are leveled with the ground, install
Brace 3 using at least 2 deck screws at each connection.
3) Once all braces have been installed, Brace 1 can be attached to
your tree using deck screws. Ensure that the platform stays level
once attached to your tree.
4) Take the 4 posts and position them where they will be installed.
Placement of the posts will depend on the levels of the ground.
Ensure that the 2 taller posts are positioned close to the back of
the platform near the tree, and the 2 shorter posts are positioned
near the front.
5) Using the sledgehammer, securely drive the posts into the
ground and attach to the outside of the stringers using a
minimum of 4 deck screws per connection.