Installation guide

Quick Guide for Professional Installers

This is a summary of the installation process. This section is

designed for use ONLY by the experienced professional installer.

AdventistSat equipment is preprogrammed to receive all Adventist

Television and Radio Services on satellite AMC4. Follow these steps

to activate the preprogrammed channels.

If needed, press the VOL/RIGHT arrow button to select an

alternative language.

Skip this step for default English selection.

Activate Preprogrammed Channels

Connect the satellite receiver TV OUT

to the television set Antenna IN. Place the

Output Selector Switch on the back of the

receiver to Channel 3 or 4 and select the same

channel on the television set. Power ON both

the satellite receiver and the television set.

Press the STB button on the remote to

control the satellite receiver with the universal

programmable remote control.

Press the MENU button.

Press the CH/UP arrow to select

Factory Reset.

Press OK.

Enter 1010 with the numeric keypad.

When prompted with the onscreen

message “Do you want to load special

data?”, select YES and press OK.

After the second “Wait a Moment” on-

screen prompt disappears the receiver will

reset and display a channel banner across

the bottom of the screen for Channel 1, the

Hope Channel.

The channel activation is complete.

10.