Owner`s manual

User Preference Settings
Use the following sequence of
commands to select the
appropriate Language, Time Zone,
Distance Units and Voice Guidance
voice:
1. Language: Main Menu> Setup
> User Preferences>
Language Settings> (select
language)
2. Set Time: Main Menu> Setup>
User Preferences> Set Time>
(use keypad to enter time) > ./
3. Distance Units: Main Menu> Setup> User Preferences> Distance Units Setup>
(select unit of measurement)
4. Voice Guidance: Main Menu> Setup> User Preferences> Voice Guidance>
(select voice)
NOTE: Your clock time must begin with 1, 2 or O. For example, enter "0835" for
8:35 and then press
AM or PM, or press 24 for 24-hour clock display (military
time). If you press 24 after entering "08:35", the time will automatically
be set for
AM, since "08:35
PM would be "20:35" in 24-hour display mode.
Change Default Location
By default, the system location is Alabama. Use the following sequence of commands
to change the default location:
Main Menu> Setup> Location Reset.
NOTE: The correct location is necessary for accurate results when using
Simulation mode.