User guide

33. MANUAL DATA BACK-UP/RESTORE FUNCTION
All system configuration and radio device data is automatically saved to a removeable memory card.
In the event of complete system failure the card can be swapped to a new controller and the original
settings can be quickly restored. Note: a manual back-up/restore can only be performed for 60
seconds following a system reset.
SYSTEM DATA BACK-UP: 1. Press the Line key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 8010 followed by the  key
4. All system data will be saved to the memory card
5. Wait for the “Ready” prompt in the earpiece
6. Press the Line key to clear the connection
RADIO DEVICE DATA BACK-UP: 1. Press the Line key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 8020 followed by the  key
4. All radio device data will be saved to the memory card
5. Wait for the “Ready” prompt in the earpiece
6. Press the Line key to clear the connection
The following codes should be used by an Engineer when the card is fitted into a new controller;
SYSTEM DATA RESTORE: 1. Press the Line key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 9010 followed by the  key
4. All system data will be copied from the memory card
5. Wait for the “Ready” prompt in the earpiece
6. Press the Line key to clear the connection
RADIO DEVICE DATA RESTORE: 1. Press the Line key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 9020 followed by the  key
4. All radio device data will be copied from the memory card
5. Wait for the “Ready” prompt in the earpiece
6. Press the Line key to clear the connection
15 September 2009 FM0420 issue D Page 22