User guide

15. USING THE LOCAL OFFSITE FACILITY
The Advent xt system may have a Local Offsite facility to divert calls to mobile warden via a standard
mobile telephone (or any other fixed telephone with a DTMF keypad).
Answering a call in Local Offsite mode is identical to the procedure for onsite mode except a site
identification message is added so that several different schemes can be identified.
The procedure for cancelling a Local Offsite call differs slightly from the onsite procedure, see below;
TO ANSWER A LOCAL OFFSITE CALL: 1. Press the Line key (or lift the handset)
2. Listen to the site ID and alarm message in the earpiece
3. Press the  key to open speech
4. Speak to the resident, stop speaking to listen
5. To end the call press the # key once
6. Wait for the “Ready” prompt in the earpiece
7. Press the # key again
8. Wait for “2 Tones” in the earpiece
9. Press the LINE key (or replace the handset)
TO MAKE A LOCAL OFFSITE CALL: 1. Press the LINE key (or lift the handset)
2. Dial the site telephone number (inc. STD Code)
3. Wait for “2 Tones” in the earpiece.
4. When answered press the # key once.
5. Wait for the “Ready” prompt in the earpiece
6. Use the system as you would in onsite mode
7. Clear the call as described above
The maximum duration for a Local Offsite call is normally set at 2 minutes - this can be extended if
necessary. This time-out prevents the Advent xt system being held with a “call in progress” should the
mobile telephone lose a signal or be cut-off for whatever reason.
16. SETTING THE LOCAL OFFSITE DIAL SEQUENCE
Up to six Local Offsite telephone numbers can be programmed into the Advent xt system. The order in
which they are dialled can be changed by entering a special code via the DECT telephone.
SET LOCAL OFFSITE DIAL SEQUENCE: 1. Press the Line key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 4007 followed by the  key
4. The current dial sequence will be announced
5. Wait for the “Ready” prompt in the earpiece
6. Press the Line key to retain the current sequence
or, enter a new sequence followed by the  key
or, press the # key to disable/re-enable the sequence
7. The new dial sequence will be announced
8. Press the Line key to clear the connection
CLEAR LOCAL OFFSITE DIAL SEQUENCE: 1. Press the Line key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 4008 followed by the  key
4. Wait for the “Ready” prompt in the earpiece
5. Press the Line key to clear the connection
Note, if no sequence is specified the numbers will be dialled in order from number 1 - see the table at
the back of this manual for a list of numbers available.
15 September 2009 FM0420 issue D Page 11