Model: CCS562 Commercial Camera System (IR Camera & 5.6” Monitor) Installation Manual Features • • • • • • • 5.6” High Resolution LCD Monitor Built in Speaker Two video inputs Fully Adjustable Auto brightness adjustment Commercial camera with Infra Red Capability and Built in Microphone using Sony CCD technology. 12v or 24v power.
Table of Contents Warnings ......................................................................................3 Product Description .....................................................................4 Packing List .................................................................................4 System Installation......................................................................5 Wiring Diagram ...........................................................................7 Specifications ............
Warnings The product is intended to assist in safe driving and to allow the driver to have a broader rear view while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle.
Product Description This advanced high resolution monitor and camera system will show a clear picture from a reversing camera or any other video source. The heavy duty design and high quality components make the CCS562 ideal for all industrial and commercial applications. The integrated wiring harness and single power wire make this system simple and fast to install. Packing List CCS562 Parts Barcode # Quantity Monitor 30272030 1 Camera 30272390 1 20M Extension Cable & 2 Adaptors 30272170 1 2.
System Installation 1. 2. 3. 4. 5. 6. 7. 8. 9. Choose the mounting location for the CAM150 commercial camera on the rear of the vehicle. We recommend a position as high as possible and in the center of the vehicle. Choose a suitable place in the vehicle cabin to mount the 5.6” LCD Screen. We recommend dash mounting in the corner of the vehicle.
Wiring the Camera to the Vehicle’s Reverse Lamp 1. Locate the reverse lamp in the tail light assembly. 2. Using the tap connector supplied, perform the following steps: a) Place the un-stripped positive lead from the tail lamp in the run channel, which runs completely through the connector. b) Insert the un-stripped red power wire from the camera completely into the other channel in the connector.
Wiring Diagram Note: The power and signal will be provided through a single cable from the monitor.
Specifications 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Voltage: DC12V-DC24V Current: 7w LCD Brightness: 350cd/m2 LCD Contrast Ratio: 300:1 Image Display: Selectable Normal/Reverse Image LCD: Adjustable Viewing Angle Camera Viewing Angle: 150 degrees Minimum Illumination: 0 Lux (w/ Infra Red) Horizontal Resolution: 420 TV Lines Dimensions: LCD (150x126x27)mm Camera (82x73x58)mm Troubleshooting Symptom Solution No power to the monitor 1. 2. 3. 4. No image from backup camera when vehicle placed in reverse 1. 2.
7
© 2008 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y.
